Tuesday, September 29, 2009

Shrink Plastic Halloween Earrings



Aren't these fun? The images are from the current SU! set "Batty For You" & the retired set "Bitty Boos." I made them with black shrink plastic (like Shrinky Dinks). I really like the black because I don't think it looks obvious that it's shrink plastic.

First, stamp the image (straight up & down--it's a slippery surface--you can sand it in a criss-cross pattern to prevent sliding if you don't have a steady hand). On black, I recommend Chalk Inks...they showed up much more vibrantly than Craft or pigment inks.

Then punch the image out (I used a 1 3/8" circle punch for the image & a 1/8" hole for the jump ring). Be very careful when punching because the ink can smear. Also, make sure you didn't get ink on your punch because then you could transfer it to the next image. Next, all you need is a heat tool to shrink them. I keep a paper piercer in the little hole to keep the plastic from blowing away when I'm trying to heat it. The finished size is about 1/2" in diameter--perfect for casual earrings.

Finally, just add jump rings & earring findings. Going to a Halloween party? Give the hostess a pair of  "The ghostess with the mostest" earrings :)
Share/Save/Bookmark

3 comments:

  1. These are great, I never seem to have any luck with shrinkys. They alway shink more than I wanted. Oh well, yours are just to cute.

    ReplyDelete
  2. These are looking very nice. Really cute, simple earrings! I love your work!

    ReplyDelete